Anonymousprnt::Y
Click on images to see them in full screen

Hardware setup

Configuration of Motion Sensors is performed using a local PC. The general steps are:
  1. Installing the Service software
  2. Installing the Sensors Viewer
  3. Attach the electronics to your PC using using a USB cable
  4. Run the view and configure IP addresses and ports
The IP address and the UID you get in this process is required for the Door Tablet software configuration.

Software download and installation
There are two programs you will need to install, both are available from the Door Tablet web site and are provided in one zip file. The zip file contains two installers and both need to be installed onto a Windows PC. One of these will be installed and run as a service. The other one, the viewer, can be used whenever you wish to configure sensors for your network.

Downloads in the door-tablet.com Downloads area...


The installed service is called "Brick Daemon"


The second program is the Brick Viewer - which you can use for configuration. The Brick Viewer will appear on your installed applications.


Configure your Sensors
To configure your sensors do the following:
  1. Open the sensors electronics box (use a screwdriver to loosen the four corners, do not undo the two silver screws)
  2. Locate the mini USB socket
  3. Use an appropriate USB cable to connect the electronics to your PC
  4. Run the "Brick Viewer"




Wired Sensor
A wired sensor comes in two types: PoE and LAN+USB Power. The following configuration applies to both. When connecting to a PoE sensor, the USB cable provides the power. Later when you connect the PoE cable this will be the only cable used.



Switch to the Master Brick tab...




Click on the Motion Detector Tab:

Make a note of the IP address and Unique ID (UID) of the Motion Detector.

Another Note: when connecting the hardware to the network wire with the PoE feed and the mini USB, connect the network first and wait for DHCP to obtain the address (say 3 seconds), then connect the mini USB cable.


Wi-Fi Sensor
Connect your Wi-Fi sensor to your PC using the USB cable. At the end of this configuration you will end up with an IP address and a Unique ID (UID) for the Motion Detector.


Switch to the Master Brick tab...


Click on the Motion Detector Tab:

Make a note of the IP address and Unique ID (UID) of the Motion Detector.