Anonymousprnt::Y
Find:

   |


 
 
Click on images to see them in full screen

Crestron Displays

From V10.0.10 you may run Door Tablet on Crestron display hardware. You may also use Crestron motion sensors available for integration with the Door Tablet software.

Getting started

  1. Ensure that your device firmware contains the Door Tablet software. For exact models contact us or your Crestron seller
  2. Open your device in a browser and create a username and password
  3. Login to your device
  4. Click on Settings
  5. Navigate down to the Applications Tab
  6. Select Door tablet from the Application Mode
  7. Type the Door Tablet server URL
  8. Pair with an Occupancy Sensor
See images below.

Login to your device


Your device shows the dashboard


Switch to Settings


About the Door Tablet URL
The URL is used when creating server connections in the Door Tablet app. The value is used as the default address, and you can modify it if needed. Please remember to add a port number if the server was configured to use a none-standard port. By default the Door Tablet server uses port 81 for http. Its easy to change the port number if it conflicts with an existing port, or if you wish to use the default port 80.

You are now ready to save the setting and reboot the device. The Door Tablet app will start after the reboot.
Next step, configure the App, see here Database 'Door Tablet HELP', View 'Help Documents', Document 'Configure the App'

Pairing a Crestron Sensor
If you wish to install a sensor and pair it with the device outside your room, go to Device Pairing, as follows:

Note: it is recommended that the IP of the sensor is set to be fixed. The display device IP address may remain dynamic.


For directions on enabling Sensor usage in Door Tablet, start here: Database 'Door Tablet HELP', View 'Help Documents', Document 'Software setup'
If you are deploying Door Tablet POE motion sensors, follow directions here: Database 'Door Tablet HELP', View 'Help Documents', Document 'Hardware setup'