Wayfinding & Floorplans
Meeting Room displays
DTSI - DT standard interface
Test on your network
Test on Demo Server
Login to Door Tablet
Our help system contains many pages and videos for you to consume. This includes the complete information on how Door Tablet works, all its features and options, and of course the many benefits for your business. Door Tablet School offers many videos too.
Show Help Navigator
Hide Help Navigator
Click on images to see them in full screen
The Door Tablet sensors are easy to configure and install. The following steps are required:
Prepare your sensors by first attaching them to your PC using a USB cable
Configure the sensor and note some connection information
Install the sensors in the
of a meeting space, and provide them with both power and network connection
Test connection to the sensor from the tablet outside the meeting space
Configure Door Tablet to indicate that sensors are used, and how you wish the system to react to motion
Door Tablet also support Crestron Occupancy sensors... see here:
Motion Sensor are connected to the network electronics in a protective box.
Sensor Configuration Types
The Door Tablet sensors come in four forms. In all cases the sensors are connected to your internal ethernet network.
PoE powered and networked
Ethernet with local, in
ceiling, USB power source
Wi-Fi with local, in ceiling, USB power source
USB only connection for Windows based end-point devices such as Door Tablet WM, Door Tablet MM and Intel UNITE hub. See here
Placing your sensors
In smaller meeting spaces simply place the sensors above the meeting space main table
In larger meeting spaces place the sensors in the places people are likely to be seated
The size of the Motion Sensor with its protective case is 4x2x6cm.
Changing Sensors Sensitivity
You may change the sensitivity of the sensor by turning the right
which controls the detection range (3-7m). Turning the potentiometer clockwise increase the range.
Configure Network Connection
To configure your new sensor follow these steps:
Open the electronics box, where the circuitry resides.
Use a screw driver in the the four corners of the case. Do not undo the two screws in the front of the box
Connect the circuitry to to your PC using a USB cable
Proceed with software installation
The networking and power components of the sensor are stored in a protective box you will be placing inside the ceiling space.
PoE based sensor:
Learn how to configure your sensors here
When using Windows devices you may connect the sensor circuitry directly to the Windows device using a USB cable. Hence, the circuitry will no longer be on the network and instead it will be connected directly to the end-point.